Abstract
The paper reports the technology allowing the assessment of the operation process of a cutter of which an operation part is hardened by the impact of low-temperature plasma with the combined category. A basis for the assessment makes a modeling of a tool operation process allowing the formation of a change path of its state through defect parameters formed on the hardened working part and a design circuit of its self-organization. On the basis of modeling results there is defined an index characterizing the time of tool steady operation. An experimental test of technology is carried out which has shown that it allows obtaining information on basic regularities and reasons of changes in the state of the hardened tool, carrying out the search of directions to increase its operational reliability and estimating the increase quantitatively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Science intensive technologies in mechanical engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
